Home › Sump Pumps › Fishers
Fishers, IN · A short drive from our Carmel shop
Sump Pump Repair & Installation in Fishers, IN
We repair and replace sump pumps in Fishers, install battery backups and high-water alarms, and fix the float switches, check valves and discharge lines that cause most failures. If a repair will do, we'll tell you.
How it works
What we check on every sump pump call
The whole system, not just the pump
Drain tile, pit, pump, check valve and discharge line
Water from the drain tile collects in the pit, the float starts the pump, and the pump pushes the water through the check valve and out to the yard. A problem at any step can flood a basement, so we look at all of it.
Read our sump pump guide →Services
Fishers sump pump services
Sump pump replacement
Our go-to is a StormPro 1/3 HP cast-iron and stainless steel submersible, with a 1/2 HP option for pits that run constantly.
Sump pump repair
Stuck floats, failed check valves, clogged screens and wiring problems are often a repair, not a new pump.
New pit and pump installs
New basins, pumps and discharge lines for basements that don't have one or need a better setup.
Battery backup pumps
A second pump that takes over automatically when the power goes out or the main pump fails.
High-water alarms
A loud warning when the water in the pit rises too high, before it reaches the floor.
Discharge line repair
Cracked, frozen or too-short discharge lines that send water back toward the house.
Sump pumps in Fishers
Fishers sits between the White River on the west and Fall Creek and Geist Reservoir to the south and east. Homes on low lots, near ponds or close to the water tend to have a higher water table, so their sump pumps run more often.
Like most of Hamilton County, Fishers has a lot of clay soil that holds rain against the foundation. Spring storms and fast snowmelt are when pumps get pushed hardest, and when a stuck float or a tired motor shows up. A quick test before the wet season goes a long way.
Repair or replace?
A stuck float, a bad check valve or a clogged screen can often be fixed. It's usually time to replace the pump when it's 7 to 10 years old, the motor hums but doesn't move water, it trips the breaker or runs hot, or the housing is cracked or badly rusted.
We'll show you what we found and give you options with prices before any work starts.
Where we work in Fishers
All of Fishers: 46037, 46038 and the Fishers side of 46040, from the Geist and Saxony areas to the Nickel Plate District. We also cover nearby Carmel, Noblesville and McCordsville.
Questions
Fishers sump pump FAQs
How do I test my sump pump?
Slowly pour a bucket of water into the pit. The float should rise, the pump should start, and the water should drain fast and shut the pump off. If it doesn't, call us.
My pump hums but doesn't pump water. Can it be fixed?
Sometimes it's a jammed impeller or a clogged screen. If the motor itself is failing, or the pump is 7 to 10 years old, replacement is usually the better value.
Do you install battery backup sump pumps in Fishers?
Yes. We can add a battery backup when we replace your pump or on its own, along with a high-water alarm.
What pump do you install?
Our go-to is a StormPro 1/3 HP cast-iron and stainless steel submersible. We step up to 1/2 HP when the pit runs constantly or the discharge line is long.
How much does it cost?
It depends on the pump, the pit and the discharge line. You get options and a price before any work starts.
Sump pump trouble in Fishers?
Call or text. If water is coming in, tell us and we'll prioritize it.
